Analog switch integrated chips (ICs), then turned on, will conduct both analog and digital signals from the input pin to the output pin. Digital switches can only accept digital signals and duplicate the logic level on the input pin at the output pin. When the digital switch is turned off, it returns to a default […]
ADCs: sufficient sampling at Nyquist’s rate
Converting a real-world (analog) signal into a digital signal means that you have to bring the signal into an Analog-to-Digital converter (ADC). From there, the ADC turns the continuous analog signal into a discrete, digital signal by sampling, or taking regular snapshots of, the curves of the analog signal. After sampling is complete, any information […]
What is leakage current?
Leakage current flows unexpectedly in almost all circuits, even when the power is off. Current leakage is not limited to electronics, computers, or small signal circuits, and can be found in industrial equipment and three-phase wiring installations, too. Some current will always find a path to ground whether it’s through ground-conducting insulation that’s supposed to […]
Selecting an op amp
You could start with a similar op amp from a similar, known-good circuit or reference design and extrapolate from there. However, not everything labeled a reference design has actually been built and tested. But there’s another way to get organized and feel in control of the selection process. A methodical approach is outlined below that […]
Compensating for DAC Offset and Gain Error
Digital-to-analog converters (DACs) are subject to gain and offset error. Errors can be compensated for with hardware by using external components or by trimming the DACs after they have been manufactured. Trimming is necessary because the error is caused by mismatched resistors; trimming attempts to change resistor values in the DAC. However, some DACs can […]
What is a multiplying DAC?
Multiplying digital-to-analog converters (MDACs) produce a (current) output signal that’s a product of the given reference voltage and the code (i.e., a string of 0s and 1s) flowing through it. All data converters require a voltage reference (VREF) and a typical, standard DAC needs a very stable fixed reference voltage in order to operate properly. […]
Selecting an optocoupler to isolate a PWM
An optocoupler (or optoisolator) is a device that galvanically separates circuits and is not only great at isolation but allows you to interface to circuits with different ground planes or that operate at different voltage levels. Optocouplers are “fail safe” in that if subjected to voltages higher than the maximum rating, they are known to […]
Stray current and parasitic capacitance in circuits at RF
Strange things can happen at high frequencies. It begins with stray current in your printed circuit board (PCB). What is stray current? Stray current starts with stray voltage, relating through Ohm’s Law (V=IR). Stray voltage refers to a situation where between two points, there exists a voltage potential that should not be there (and wouldn’t […]
What is inrush current?
Inrush (in-rush) current is a sudden large flow of current that exceeds the usual, steady-state operating current, and can be a problem for any circuit. Inrush is most often associated with turning on equipment. Inrush current can be caused by large-capacity decoupling capacitors that draw a lot of current as they initially get charged up. […]
The post What is inrush current? appeared first on Power Electronic Tips.
Basics of bandpass filters
Filters will allow some signals to pass through while blocking others. A bandpass (a.k.a. band-pass) filter allows signals of a certain frequency range (“a band of frequencies”) to pass through the filter as-is. (This range of accepted frequencies is called the passband. The size or range of the passband is called the bandwidth.) With a […]
The post Basics of bandpass filters appeared first on Analog IC Tips.