The automotive ADAS designers tout the up-and-coming LiDAR detection technology, coupled with mmWave radar and the camera, to support autonomous vehicle design further. But this is not the complete LiDAR story. Let’s see what happens when engineers get this new toy. This technology, combined with GPS, is finding a home in agriculture, astronomy, oceanography, cameras, […]
The practical magical first-order analog filter: Part 1
Finding the right analog filter to build a sensor circuit doesn’t have to be complicated. Understandably, the plethora of filter options can be overwhelming. Also, selecting a less-than-ideal filter may result in compromises, potentially increasing system cost, or affecting performance. To help simplify filter selection, this series of blogs explore key considerations when assessing your […]
A look at intrinsic broadband noise spectral density
You can think of noise as an unwanted signal. This signal creates an error by combining with the desired signal in your circuit. Exterior sources can couple into your circuits, such as your 50 or 60 Hz DC mains signal or your cell phone. The starting point in your circuit’s noise evaluation is to reach […]
Squash 1/f noise with zero-drift amplifiers
There is a device that squashes all the 1/f voltage and current noise calculations with a chopper amplifier algorithm that corrects offset and drift characteristics. These amplifiers are zero-drift, auto-zero, or choppers that all achieve nanovolt-level offsets and extremely low offset drifts due to time and temperature. But back to our noise discussion, these devices […]
Including the often overlooked 1/f current noise
It is tempting to center your attention only on voltage noise when using operational amplifiers in the circuit. This impulse is attractive because the current noise is always well below the voltage noise specifications. But be careful. Don’t jump to conclusions without looking at all the elements in this noise challenge. This blog explores the […]
Negotiate through 1/f noise challenges towards sample sizes into the 100s of years
Measuring and determining 1/f voltage noise over a multiple-year sample requires an operational amplifier and effective 1/f knowledge. This article shows how to identify and determine the actual op amp 1/f voltage noise across a sample size of years and explains why the 1/f voltage noise is a non-issue at higher frequencies. After many years […]
